If additional slack is required in the I/O device assembly cables, disconnect the cables from the
system board.
5. Disconnect the control panel cable harness from the system board (as shown in the following
figure).
Figure 4-15 Disconnecting the control panel assembly cable
TIP: Remove the optional PCI card guide (if installed) and installed hard drives before attempting
to feed the control panel wiring harness out the front of the workstation chassis.
6. If an optional hood sensor is installed, disconnect the white 1x3 hood sensor connector from its
mating in-line connector attached to the front panel harness.
7. Disconnect the white speaker cable connector from its mating in-line connector attached to the
front panel harness.
8. Remove the power button assembly mounting screw and rotate the assembly out and away from
the chassis while feeding the power button assembly cable out through the front of the chassis, as
shown in the following figure.
Figure 4-16 Removing the power button assembly
66 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
