To install a SAS hard drive:
1. Disconnect power from the system (see
Predisassembly procedures on page 52).
2. Remove the side access panel (see
Side access panel on page 58).
3. Attach a SAS-to-SATA cable adapter to the connector on the SAS hard drive, as shown:
Figure 4-44 Attaching the SAS-SATA adapter to the SAS hard drive
4. Install the hard drive body into the hard drive mounting rails, as shown:
Figure 4-45 Installing the hard drive body into hard drive mounting rails
ENWW Removing and replacing components 89
To Next Page
Loading...
