Sliding Rack Mount Kit Installation
HP Workstation xw8200
This document describes how to install the sliding rack mount kit on an HP Workstation xw8200 and how
to install the unit into a rack. This sliding rack mount kit works with HP, Compaq, and some third-party
racks. The rack mount slides can fit racks 24–30 inches deep.
Kit Contents
This product is shipped with the necessary supplies for installing the Sliding Rack Mount Kit on an HP
Workstation xw8200 in a round hole, square hole, threaded hole, and earlier HP racks. The following list
describes all of the included parts. Not all parts are used with every installation.
■ Slide assembly (x2) (adjustable from 24–30 inches)
■ Left and right mounting flanges
■ M5 hardware packet—M5 screws (x12) and M5 clip nuts (x12)
■ M6 hardware packet—M6 screws (x12) and M6 clip nuts (x12)
■ 10-32 hardware packet—10-32 screws (x12) and 10-32 clip nuts (x12)
Tools Required
■ T-15 Torx driver
■ T-25 Torx driver
■ Phillips driver
■ Flathead driver (possibly for third-party racks)
To Next Page
