3. Install the memory riser card guide into memory slots 2, 4, 6, and 8 in the workstation chassis. Align
the card guide, and then press it securely into the slots as shown in the following figure.
Figure 4-36 Installing the riser card guide
4. Install the memory DIMMs in the memory riser cards as shown in the following figure.
Begin installing DIMMs in the lower-most slots, nearest the system board.
Figure 4-37 Installing DIMMs in the memory riser board
5. To assure proper airflow to the DIMMs, install blank memory riser fillers in all unused slots on the
riser board.
82 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
