Step 4—Connecting the power
1. Close the expansion slot retention clamp to secure the card in the slot .
2. Connect the 6-to-8 pin auxiliary power adapter cable, supplied with this kit, to the workstation
auxiliary power supply
2
, and then to the FX5800 card .
NOTE: No connection is made at point . If a label covers the outlet at , do not remove it.
Figure 6 Installing the 6-to-8 pin power adapter cable
Step 5—Installing the card support
HP xw8600 and xw9400 Workstations
To prepare and install the card support bracket:
1. Insert an additional arm in the card support
, if applicable.
2. Slide the arm back to lock it into place
2
.
3. Hook the support bracket in the openings along the edge of the rear of the chassis
.
4. Compress the spring of the support arm until the arm locks into place
.
Figure 7 Installing a card support (HP xw8600 and xw9400 Workstations)
ENWW Step 4—Connecting the power 7
To Next Page
Loading...
