Using Computer Setup (F10) Utility
You can call up the Computer Setup Utility during workstation restart or power on. To access the
Computer Setup Utility menu:
1. Power on or restart the workstation.
2. Press the F10 key as soon as your display is active and the message Setup appears in the lower
right corner of the screen.
NOTE: If you miss the opportunity to press F10, restart the workstation and press F10 again. Or,
you can press Ctrl+Alt+Delete prior to boot .
3. At first boot, select your language from the list, and press the Enter key. In the Computer Setup
Utility menu, five headings are displayed: File, Storage, Security, Advanced, and I/O.
4. Use the left and right arrow keys to select the appropriate heading. Use the up and down arrow
keys to select the option you want, and press Enter.
5. To apply and save changes, select File>Save Changes and Exit.
●
If you have made changes that you do not want applied, select File>Ignore Changes and
Exit.
●
To reset to factory settings, select File>Default Setup>Restore Factory Settings as
Default. Press F10 to accept the changes. Click File>Apply Defaults and Exit. This option
restores the original factory system defaults.
CAUTION: Do not turn the workstation power off while the ROM is saving your Computer Setup Utility
changes because the CMOS could become corrupted. After you exit the F10 Setup screen, it is safe to
remove all power from the workstation.
ENWW Computer Setup (F10) Utility 27
To Next Page
Loading...
