Front panel I/O device assembly
To remove the front panel I/O device assembly:
1. Disconnect power from the system (
Pre-disassembly procedures on page 55). Remove the access
panel (
Access panel on page 63) and the front bezel (Front bezel on page 64).
2. Unlatch the plastic snap that secures the cables inside the chassis and, disconnect the front panel
I/O device assembly cables from the system board.
3. Remove the screws that hold the front panel I/O device assembly and bracket to the chassis, and
remove the screws that hold the front panel I/O device assembly to the bracket.
4. Pull the front panel I/O device assembly out about two inches away from the chassis.
5. Pull the bracket away from the front panel I/O device assembly.
Figure 5-9 Removing the front panel I/O device assembly
6. Slide the front panel cables through the chassis and out the front of the unit.
To replace the front panel I/O device assembly, reverse the previous steps.
66 Chapter 5 Removal and replacement procedures ENWW
To Next Page
Loading...
