NOTE: DIMMs and DIMM sockets are keyed for proper installation. Be sure these guides align
when installing a DIMM.
6. Lower the memory fan until it snaps into place.
NOTE: Ensure that all cables are clear of the fan housing when lowering the memory fan.
The BIOS generates warnings/errors on invalid memory configurations.
●
If BIOS cannot obtain a valid memory configuration, it will halt the system with a diagnostics 2006
code for memory error (five beeps and blinks).
●
If memory node interleave is enabled but the memory installed on the two CPUs is not equal, BIOS
will report a warning during POST (“215-Cannot Interleave Unequal Memory Nodes”). The system
can still boot in this condition.
76 Chapter 5 Removal and replacement procedures ENWW
To Next Page
Loading...
