PCI retainer
For added protection, some cards have PCI retainers installed to prevent movement during shipping.
Removing the PCI retainer
1. Disconnect power from the system (
Pre-disassembly procedures on page 55), and remove the
access panel (
Access panel on page 63). Place the workstation on its side with the system board
facing up.
2. For both short and tall cards, press in on the sides (1) of the retainer, and rotate it (2) out of the
chassis.
Figure 5-20 Removing the short or tall card PCI retainer
Installing the PCI retainer
1. Disconnect power from the system (
Pre-disassembly procedures on page 55), and remove the
access panel (
Access panel on page 63). Place the workstation on its side with the system board
facing up.
78 Chapter 5 Removal and replacement procedures ENWW
To Next Page
Loading...
