Battery
CAUTION: Before removing the battery, be sure your CMOS settings are backed up because all
CMOS settings are lost when the battery is removed. To back up the CMOS settings, use Computer
Setup and run the Save to Diskette option from the File menu.
To remove the battery:
1. Disconnect power from the system (
Pre-disassembly procedures on page 55), and remove the
access panel (
Access panel on page 63). Place the workstation on its side with the system board
facing up.
2. On the system board, press on the release tab of the battery holder.
3. Rotate the battery enough to get beyond the latch, and lift it straight up.
Figure 5-33 Removing the battery
To install the battery, slide the battery into the holder until it snaps into place.
88 Chapter 5 Removal and replacement procedures ENWW
To Next Page
Loading...
