Solid-state drives (M.2)
Description Spare part number
256 GB, Turbo Drive, G2, MLC 921331-001
512 GB, M2 SATA-3, FIPS, TLC 921332-001
256 GB, SATA-3 self-encrypting drive (SED), Opal 2, TLC 921333-001
256 GB, Turbo Drive, G2, TLC 921334-001
512 GB, Turbo Drive, G2, MLC 921335-001
512 GB, Turbo Drive, G2, self-encrypting drive (SED), Opal 2, TLC 921336-001
1 TB, Turbo Drive, G2, MLC 921337-001
256 GB, SATA, TLC 921338-001
1 TB, SATA-3, TLC 926788-001
Before removing the SSD, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Service door (see Service door on page 30).
b. Battery (see Battery on page 31).
c. Base enclosure (see Base enclosure on page 33).
d. Hard drive(s) and internal frame (see Hard drive(s) and internal frame on page 33).
Remove the SSD:
NOTE: The secondary SSD is only available if a primary SSD is installed.
1. Remove the Phillips screw (1) that secures the solid-state drive to the system board.
2. Remove the SSD (2) by pulling the drive away from the slot at an angle.
38 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
