d. Hard drive(s) and internal frame (see Hard drive(s) and internal frame on page 33).
e. Solid-state drive(s) (see Solid-state drives (M.2) on page 38).
f. WLAN module (see WLAN module on page 40).
g. WWAN module (see WWAN module on page 42).
Remove the memory module:
1. Identify the location of the memory module slots (1) – (4). The system memory must be installed in the
order shown. The BIOS checks for this and will not boot if the memory is not installed into the correct
slots. The BIOS will display a message in POST notifying the user that the system memory is not
installed in the proper order.
2. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The memory module tilts up.)
Component replacement procedures 45
To Next Page
Loading...
