Items Procedures
1. See 7. Status lights, blinking light codes, troubleshooting lights, and POST error
messages on page 84 for corrective actions. An example of a POST error message is
shown below.
2. If there is power, you may be able to access BIOS. Reset BIOS to its default condition.
(9. Soft reset (Default Settings) on page 87)
3. Restore hardware to its original condition (i.e., bootable solid-state drive instead of
hard drive).
4. Reseat suspected components and verify connection.
5. Test suspected components using HP PC Hardware Diagnostics (UEFI) tool.
Note An Error Message means the system has nished BIOS hardware validation and is ready to
launch the Startup Menu. To access the Startup Menu for further options, press the Esc key
while restarting the computer.
100 Chapter 6 Troubleshooting guide
To Next Page
Loading...
