Blitz
™
No. 1200CMB
74
attentIon: Please read before ProceedIng.
re-calIbratIon of dePth
NO RE-ADJUSTMENT of depth is required when changing from one code card
to another. The depth indicator marks on each code card are positioned for correct
alignment when using the factory cutter wheels. No special washers are required
on either side of the cutter.
The need to re-adjust the depth is rare and should be done only after the more
common causes for mis-cut keys are eliminated.
Remember, when originating a key by code you do not have access to an operable
key. Quite often code numbers are mis-read, locks are coded incorrectly when
they are new and code books occasionally have typographical errors. Be aware of
these unintentional errors that detract from the successful cutting of keys by code.
After eliminating the above mentioned causes for mis-cut keys and checking for
correct calibration - then proceed.
To Next Page
Loading...
