Blitz
™
No. 1200CMB
76
The two flats on the end of the eccentric shaft allow a 3/8” open end wrench (such as
No. WRENCH-1) to rotate the eccentric shaft either towards you, making the depths
deeper, or away, making the depths shallower. There should be no need to loosen the
two set screws. The maximum range of the eccentric shaft is 90° when pulling towards
you (a maximum of -.015” in depth change) and 90° when pushing away (a maximum
of +.015” in depth change). Therefore only a small turn is used to change depths.
• Very rapid minor depth adjustments are made by comparing the depth of a cut
against the code card and then rotating the eccentric shaft slightly as required.
To Next Page
Loading...
