Blitz
™
No. 1200CMB
78
attentIon: Please read before ProceedIng.
re-calIbratIon of sPace
NO RE-ADJUSTMENT of space is required when changing from one code
card to another. The space indicator marks on each code card are positioned
for correct lateral alignment when using the factory cutter wheels. No special
spacing washers are required on either side of the cutter.
The need to re-adjust the space is rare and should be done only after the more
common causes for mis-cut keys are eliminated.
Remember, when originating a key by code you do not have access to
an operable key. Quite often code numbers are mis-read, locks are coded
incorrectly when they are new and code books occasionally have typographical
errors. Be aware of these unintentional errors that detract from the successful
cutting of keys by code. After eliminating the above mentioned causes for
mis-cut keys and checking for correct depth calibration - then proceed.
If re-adjustment of space is needed, follow the instructions for tip-gauged
space adjustments first. Then proceed with shoulder-gauged space adjustments.
Because the tip gauges are built into the bottom jaw and the shoulder gauge is
mounted on its own pivot, re-adjusting the shoulder gauge may not properly
re-calibrate your 1200CMB.
To Next Page
Loading...
