b. Detach the left chassis ear (callout 3).
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the front I/O and right chassis ear assemblyRemoving and replacing the front I/O and right chassis ear assembly
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this taskAbout this task
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm .
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Disconnect the front I/O cable from the system board .
To Next Page
Loading...
