2. If installed, open the cable management arm .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the riser cage.
9. Remove the riser slot blank.
Retain the blank for future use.
10. Make sure that any switches or jumpers on the expansion card are set properly.
For more information, see the documentation that ships with the expansion card option.
11. Install the expansion card:
Make sure that the expansion card is seated firmly in the slot.
12. Connect all necessary internal cabling to the expansion card.
To Next Page
Loading...
