3. Remove the boot device carrier:
a. Press and hold the carrier latch (callout 1).
b. Pivot the latch to open (callout 2).
c. Slide the carrier out from the boot device cage (callout 3).
4. If installed, remove the boot device drive from the carrier:
a. Remove the SSD mounting screw (callout 1).
b. Tilt the SSD with the M.2 slot at a 45° angle (callout 2).
c. Carefully remove the SSD from the M.2 slot (callout 3).
Retain the boot device drive and screw for installation onto the new boot device carrier.
To Next Page
Loading...
