ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a non-hot-plug boot device driveRemoving and replacing a non-hot-plug boot device drive
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a Phillips No. 1 screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm.
To Next Page
Loading...
