CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. If you are replacing the energy pack from the retention latch, remove the middle cover .
9. To remove the energy pack from the holder, do the following:
a. Disconnect the cable (callout 1).
b. Press and hold the release latch (callout 2).
c. Lift one end of the energy pack and release it from the holder (callouts 3 and 4).
To Next Page
Loading...
