ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the front USB and DisplayPort Y-cableRemoving and replacing the front USB and DisplayPort Y-cable
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
T-10 Torx screwdriver
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, open the cable management arm.
To Next Page
Loading...
