4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack.
7. Place the server on a flat, level work surface.
8. Remove the access panel.
9. Remove the middle cover.
10. Disconnect the front USB and Display cable from the system board .
11. If you are removing the front USB and DisplayPort Y-cable from the optical drive cage, disconnect the optical drive cable from the
system board.
12. To remove the front USB and DisplayPort Y-cable from the LFF drive chassis:
a. Remove the front USB and DisplayPort assembly.
Retain all screws. These screws will be used to secure the assembly after the front USB and DisplayPort Y-cable replacement.
To Next Page
Loading...
