ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the serial port blankRemoving and replacing the serial port blank
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a spudger or any small prying tool available.
About this taskAbout this task
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
ProcedureProcedure
1. Remove the serial port blank:
a. Detach the right side of the blank (callout 1).
b. Repeat step a on the left side to remove the blank (callout 2).
2. Immediately install the new serial port blank.
To Next Page
Loading...
