Drive controller cable
Drive power cable
17. Remove the 4 LFF drive backplane.
Retain the screws. These screws will be used to secure the new drive backplane spare.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the 2 SFF drive backplaneRemoving and replacing the 2 SFF drive backplane
About this taskAbout this task
CAUTION:CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. If installed, open the cable management arm.
To Next Page
Loading...
