HPE ProLiant DL325 - Removing and Replacing a Pcie Blank

4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Remove any expansion boards installed in the primary riser board.
7. Remove the primary riser cage.
8. Remove the riser board from primary riser cage.
a. Remove the two T-15 screws securing the riser board to the riser cage.
b. Detach the riser board from the riser cage.
To replace the component, reverse the removal procedure.
Removing and replacing a PCIe blank
Prerequisites
Before you perform this procedure, make sure that you have T-15 screwdriver available.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
48 Removal and replacement procedures