Removing and replacing a Smart Array type-a modular
controller
Prerequisites
Before you perform this procedure, make sure that you have T-15 screwdriver available.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Disconnect all cables from the type-a controller.
7. Remove the Smart Array type-a modular controller.
To replace the component, reverse the removal procedure.
52 Removal and replacement procedures
To Next Page
Loading...
