HPE ProLiant DL325 - Removing and Replacing the Optical Drive Blank

a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Remove the energy pack.
7. Remove the energy pack holder from the chassis.
To replace the component, reverse the removal procedure.
Removing and replacing the optical drive blank
Prerequisites
Before you perform this procedure, make sure that you have T-10 Torx screwdriver available.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
54 Removal and replacement procedures