To replace the component, reverse the removal procedure.
Removing and replacing the quick-release latch ears
Prerequisites
Before you perform this procedure, make sure that you have T-10 screwdriver available.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the quick-release latch ear.
• Right latch ear
58 Removal and replacement procedures
To Next Page
Loading...
