Removing and replacing a hot-plug power supply
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all
bays are populated with either a component or a blank.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Access the product rear panel.
4. Release the power cord from the strain relief strap.
5. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
6. Remove the power supply.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
Removal and replacement procedures 71
To Next Page
Loading...
