To replace the component, reverse the removal procedure.
Removing and replacing the Power Distribution Board
To perform this procedure, you will need a T-15 screwdriver.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Remove all hot-plug power supplies.
7. Disconnect the power and signal cables from the power distribution board (PDB).
8. Remove the PDB.
a. Remove three T-15 screws.
b. Remove the PDB cover.
c. Remove the PDB.
72 Removal and replacement procedures
To Next Page
Loading...
