4. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
5. Remove the access panel.
6. Remove the DIMM.
To replace the component, reverse the removal procedure.
Removing and replacing a heatsink
To perform this procedure, you will need the following:
• T-20 screwdriver
• Alcohol wipe
Procedure
1. Observe the following alert.
CAUTION: When handling the heatsink, always hold it along the top and bottom of the fins.
Holding it from the sides can damage the fins.
2. If installed, remove the bezel.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
Removal and replacement procedures 75
To Next Page
Loading...
