12. If removed, install the air baffle.
13. Install the access panel.
14. Install the server into the rack.
15. Power up the server.
16. Install the bezel.
Removing and replacing a processor
To perform this procedure, you will need the following:
• T-20 screwdriver
• Thermal grease (part number: 777298-001)
• Alcohol wipe
Procedure
1. Observe the following alerts.
CAUTION: When handling the heatsink, always hold it along the top and bottom of the fins.
Holding it from the sides can damage the fins.
CAUTION: To avoid damage to the processor or system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
Removal and replacement procedures 77
To Next Page
Loading...
