HPE ProLiant DL345 Gen11 - Results; Removing and replacing an expansion card from PCIe5 x16 low-profile riser; Prerequisites; About this task

ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing an expansion card from PCIe5 x16 low-profile riserRemoving and replacing an expansion card from PCIe5 x16 low-profile riser
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either a
riser slot blank or an expansion card installed.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
HPE ProLiant DL345 Gen11 Server Service and Maintenance Guide 126