HPE ProLiant DL360 Gen11 - Controllers

DescriptionDescription Spare partSpare part
numbernumber
SPS-CA kit, 20EDSFF to CPU2 MCIO,pwr P56478-001
8SFF U.3/U.2 BP power connectors:
U.3/U.2 backplane power cable
2SFF to 8SFF power cable
P56475-001
Port 9/10/11 to OCP Slot15 Port1/2 P52801-001
8SFF U.3/U.2 slimSAS to MLB P52802-001
8SFF U.3 x1 to MLB P56476-001
2SFF slimSAS to CPU1/CPU2/MLB P56477-001
NS204i-u front power (SFF) P56479-001
8SFF/2SFF U.3 x1/U2 to controller P53222-001
8SFF U.3 x4 to controller 1/2/3/4 P56480-001
8SFF U.3 x4 to controller Y-cable 1/2 P56480-001
8SFF U.3 x4 to controller Y-cable1/2 P53223-001
4LFF to MR416i-p/SR308i-p P53224-001
OCP1 card to 4LFF P56483-001
OCP1 to 8SFF x1 U.3 P56484-001
4LFF DisplayPort and ODD P56485-001
8SFF Display and ODD P56486-001
4LFF to PRI/TER/8SFF SAS P24139-001
Removal and replacement proceduresRemoval and replacement procedures
SubtopicsSubtopics
Safety considerationsSafety considerations
Preparation proceduresPreparation procedures
Removing and replacing the front bezelRemoving and replacing the front bezel
Removing and replacing the cable management armRemoving and replacing the cable management arm
Removing and replacing the server railsRemoving and replacing the server rails
Remove the hard drive blankRemove the hard drive blank
Removing a hot-plug SAS/SATA/NVMe driveRemoving a hot-plug SAS/SATA/NVMe drive
Removing and replacing a hot-plug E3.S driveRemoving and replacing a hot-plug E3.S drive
Removing and replacing a power supply blankRemoving and replacing a power supply blank
Removing and replacing a hot-plug AC power supplyRemoving and replacing a hot-plug AC power supply
Removing and replacing a fan blankRemoving and replacing a fan blank
Removing and replacing a fanRemoving and replacing a fan
Removing and replacing a riser cageRemoving and replacing a riser cage
HPE ProLiant DL360 Gen11 Server Maintenance and Service Guide 38