Removing and replacing a riser cageRemoving and replacing a riser cage
CAUTION: CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all AC power cords
before removing or installing the PCI riser cage.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel.
5. Remove the riser cage.
To remove the primary riser cage:
To remove the secondary riser cage:
a. Remove the primary riser cage.
b. Open the secondary rear wall.
To Next Page
Loading...
