HPE ProLiant DL360 - Removing and Replacing the Serial Port

Removing and replacing the serial portRemoving and replacing the serial port
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel.
5. Remove all riser cages.
6. Remove the switch and then disconnect the cable.
Removing and replacing the serial port 141