Removing and replacing a storage controllerRemoving and replacing a storage controller
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel.
5. Disconnect any cables from the controller
Note the port numbers before disconnecting the cables.
6. Remove the controller.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
