Installing a redundant hot-plug power supplyInstalling a redundant hot-plug power supply
About this taskAbout this task
CAUTION:CAUTION:
All power supplies installed in the server must have the same output power capacity. Verify that all power supplies have
the same part number and label color. The system becomes unstable and might shut down if it detects different power
supplies.
CAUTION:CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with either a
component or a blank.
ProcedureProcedure
1. Release the cable management arm to access the rear panel
2. Remove the blank.
WARNING:WARNING:
To reduce the risk of personal injury from hot surfaces, allow the power supply or power supply blank to cool before
touching it.
3. Insert the power supply into the power supply bay until it clicks into place.
To Next Page
Loading...
