Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Remove the air
bale.
6. Remove the fan cage.
7. Install the energy pack option.
8.
Route and connect the cable.
CAUTION: Do not connect the energy pack while the server is operating. Verify that all power to the server has
been removed.
Hardware options installation 75
To Next Page
Loading...
