CAUTION: DIMMs and HPE Persistent Memory modules are keyed for proper alignment. Align notches on the
DIMM or HPE Persistent Memory module with the corresponding notches in the slot before installing the
component. Do not force the DIMM or HPE Persistent Memory module into the slot. When installed properly, not all
DIMMs or HPE Persistent Memory modules will face in the same direction.
CAUTION: Electrostatic discharge can damage electronic components. Be sure you are properly grounded before
beginning this procedure.
CAUTION: Failure to properly handle HPE Persistent Memory modules can damage the component and the
system board connector.
IMPORTANT: Hewlett Packard Enterprise recommends that you implement best practice configurations for high
availability (HA) such as clustered configurations.
2. Power down the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack, if necessary.
4.
Place the server on a flat, level work surface.
5.
Remove the access panel.
6.
Remove all components necessary to access the DIMM slots.
7.
Install the HPE Persistent Memory module.
8. Install any components removed to access the DIMM slots.
9. Install the access panel.
10. Slide or install the server into the rack.
11. If removed, reconnect all power cables.
Hardware options installation
91
To Next Page
Loading...
