HPE ProLiant DL385 Gen11 - Results; Removing and replacing the SFF universal media bay USB 2.0;DisplayPort Y-cable; Prerequisites; Procedure

ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the SFF universal media bay USB 2.0/DisplayPort Y-cableRemoving and replacing the SFF universal media bay USB 2.0/DisplayPort Y-cable
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
ProcedureProcedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. If installed, remove all drives from the 2 SFF stacked drive cage.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 110