HPE ProLiant DL385 Gen11 - Results; Removing and replacing an expansion card from the tertiary risers; Prerequisites; About this task

ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing an expansion card from the tertiary risersRemoving and replacing an expansion card from the tertiary risers
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either a
riser slot blank or an expansion card installed.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 131