4. Power down the server.
5. If installed, open the cable management arm.
6. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
7. Disconnect all peripheral cables from the server.
8. Remove the server from the rack .
9. Place the server on a flat, level work surface.
10. Remove the access panel.
11. Remove the fan cage.
12. Remove the midwall bracket.
13. Disconnect all cables from the 2 SFF stacked drive backplane.
14. Remove the universal media bay:
To Next Page
Loading...
