HPE ProLiant DL385 Gen11 - Results; Removing and replacing the boot device cage assembly on top of the power supply cage; Prerequisites; About this task

ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing the boot device cage assembly on top of the power supply cageRemoving and replacing the boot device cage assembly on top of the power supply cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
T-10 Torx screwdriver
Phillips No. 1 screwdriver
About this taskAbout this task
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
HPE ProLiant DL385 Gen11 Server Maintenance and Service Guide 190