4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel.
9. Disconnect all cables from the rear 4 LFF drive cage.
10. Remove the rear 4 LFF drive cage:
a. Loosen the captive screws (callout 1), and then pull the rear 4 LFF drive cage into place (callout 2).
b. Lift the rear 4 LFF drive cage (callout 3).
To Next Page
Loading...
