a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect any external cables that are connected to the expansion board.
4. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 42).
• Remove the server from the rack (Remove the server from the rack on page 42).
5. Remove the access panel (Remove the access panel on page 44).
6. Disconnect any internal cables that are connected to the expansion board.
7. If any full-length expansion boards are installed, release the full-length expansion board retainer (Release
the full-length expansion board retainer on page 44).
8. Remove the PCIe riser cage.
9. To replace the component, reverse the removal procedure.
To replace the component, reverse the removal procedure.
Removing and replacing the tertiary PCIe riser cage
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI
slots have either an expansion slot cover or an expansion board installed.
Procedure
1. Power down the server (Powering down the server on page 41).
2. Remove all power:
Removal and replacement procedures 55
To Next Page
Loading...
