• UEFI System Utilities—Use System Utilities through the Remote Console to configure the server for NVDIMM memory
options by pressing the F9 key during POST. For more information about UEFI System Utilities, see the Hewlett Packard
Enterprise website (http://www.hpe.com/info/uefi/docs).
• iLO RESTful API for HPE iLO 5—For more information about configuring the system for NVDIMMs, see https://
hewlettpackard.github.io/ilo-rest-api-docs/ilo5/.
Removing and replacing an HPE Persistent Memory module
For specific population and configuration information, see the memory population guidelines on the Hewlett Packard
Enterprise website (http://www.hpe.com/docs/memory-population-rules).
To identify the HPE Persistent Memory modules installed in the server, see
HPE Persistent Memory module label
identification.
Procedure
1. Observe the following alerts:
CAUTION: Electrostatic discharge can damage electronic components. Be sure you are properly grounded before
beginning this procedure.
CAUTION: Failure to properly handle HPE Persistent Memory modules can damage the component and the system
board connector.
2.
Power down the server.
a.
Shut down the OS as directed by the OS documentation.
b.
To place the server in standby mode, press the Power On/Standby button. When the server enters standby power
mode, the system power LED changes to amber.
c.
Disconnect the power cords (rack and tower servers).
3.
Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack, if necessary.
4.
Place the server on a flat, level work surface.
5.
Remove the access panel.
6. If installed, do the following:
a. Remove the air
bale (Removing and replacing the air bale).
b. Remove the processor mezzanine tray (Removing and replacing the processor mezzanine tray).
c. Remove the CPU Mezzanine UPI performance kit (
Removing and replacing the CPU Mezzanine UPI performance kit).
7. Remove the HPE Persistent Memory module.
62
Removal and replacement procedures
To Next Page
Loading...
