HPE ProLiant DL560 Gen10 - Removing and Replacing the HPE 12 G SAS Expander Card

Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (
Extend the server from the rack).
• Remove the server from the rack (Removing the server from the rack).
4. Remove the access panel (Removing the access panel).
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server
in this manner results in improper airflow and improper cooling that can lead to thermal damage.
5.
Disconnect all cables attached to the components in the PCIe riser cage.
6.
Remove the PCIe riser cage (Removing and replacing a PCIe riser cage).
7.
Remove the GPU card.
To replace the component, reverse the removal procedure.
Removing and replacing the HPE 12G SAS Expander Card
Procedure
1. Power down the server.
2. Remove all power:
Removal and replacement procedures
73