To replace the component, reverse the removal procedure.
Removing and replacing a Smart Array controller
Removing and replacing a type-a controller
CAUTION: Hewlett Packard Enterprise recommends performing a backup of all server data before installing or removing
a controller or adapter.
Procedure
1.
Back up all server data.
2.
Power down the server.
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Do one of the following:
• Extend the server from the rack (
Extend the server from the rack).
• Remove the server from the rack (Removing the server from the rack).
5. Remove the access panel (
Removing the access panel).
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server
in this manner results in improper airflow and improper cooling that can lead to thermal damage.
6. If installed, do the following:
Removal and replacement procedures
89
To Next Page
Loading...
